#Fusion mac emulator amiga software
#Fusion mac emulator amiga windows

Not sure what is wrong here but I have often experienced file sharing trouble between my Macs and Windows systems anyway. The default 'WORKGROUP' domain was recognized by Ubuntu also. My main Mac computer already had SMB file sharing enabled, but Ubuntu would not accept my credentials as either a registered user or guest! Oh well. So I saw that I could connect to a server. Now, I could just copy the data to one of the local NTFS volumes but I suspect something might get lost in translation with exception of simple. The latest Ubuntu not only works great on my ASUS PC, it works better than any Ubuntu ever did! All devices were recognized and the Mac partition was visible. So good news, more good news and some bad news: Why bother with all this? I strongly believe I left something important on this Mac partition and hope to be able to read it. My only other option is to find a real pre-Intel and pre-G5 Mac that will still accept my old Mac SCSI adapter. If I can successfully get Fusion to work even temporarily, I bet I can get it to see the Mac partition. Guess I can glance over the installation instructions. Whatever Fusion needs to work should still be there but it has been so long, i do not recall. The AmigaDOS parition is from the A3000 setup, though, and WinUAE was configured to match the hardware. With ShapeShifter, this is called 'PrepareEmul' and I am thinking Fusion may need something similar but cannot use what ShapeShifter is using. Perhaps something to do with that little program that needs to run in order to prepare the emulation. When I launch Fusion within WinUAE, it gurus.

#Fusion mac emulator amiga software

If I recall correctly, Fusion was very similar to the Emplant software side but had no Emplant hardware requirements. It was most likely attached to an Emplant board's SCSI connector. The drive was originally used in an A3000 I last owned. An old note I put on the drive says the partition was for use with Fusion. WinUAE sees and can boot from the AmigaOS partition on the same drive but I have not been able to make ShapeShifter see the Mac side. The problem is it is not quite working towards my goal to be able to access a Mac partition I have on an old SCSI hard drive that I have connected via an Adaptec SCSI controller. Is it possible to run the Mac emulator Fusion under WinUAE? I know it is possible to run ShapeShifter because I am currently testing it out.